[Pansophy] FW: New DocuShare document routing task (Step 1 Completion): NB3SN-CMTF-CM-ACTS-R1.docm

[Allen Samuels]

The NB3SN-CMTF-CM-ACTS-R1 traveler has been approved and uploaded to pansophy.

Allen

From: DocuShare Workflow <docushare at jlab.org>
Sent: Friday, April 19, 2024 11:32 AM
To: Allen Samuels <samuels at jlab.org>
Subject: New DocuShare document routing task (Step 1 Completion): NB3SN-CMTF-CM-ACTS-R1.docm

You have a new DocuShare document routing task:

Subject: NB3SN-CMTF-CM-ACTS-R1.docm
Date: 04/19/2024 11:32:07

Step 1 Completion:

Michael Drury, 04/15/2024 14:40:01 Approved:

Gianluigi Ciovati, 04/15/2024 14:27:04 Approved:

Mike McCaughan, 04/16/2024 10:15:42 Approved:

Steps 43/49: Update gradient targets to Emax - 1MV/m from 4K VTA data: 12.6 (cav. 7) and 8.12 (cav. 8).


Steps 59 & 63: Update targets to Eop, Eop - 2 MV/m, and Eop - 4 MV/m. Both Qos in VTA were ~2.5e9 at 4K.


Between steps 69 and 70 do we want to insert Emax measurements at 2K before taking Qos again as we should reach higher gradients? New 2K targets 17.5 (cav. 7) and 8.2 MV/m (cav. 8) [Emax,VTA - 1MV/m; copy paste steps 47-52]


Present steps 71 & 75 - I think Qo target numbers for NCR writing are swapped.


Step 78: Do we actually want to do the full +/- 500 kHz range test? Defere to Gigi/Grigory. Smaller 2K loop seems reasonable. +/- 50 kHz range probably more than sufficient.


Steps 83 & 92: New targets 17.5 and 8.2 MV/m respectively (VTA Emax - 1 MV/m)


Steps 99 and 102: Qo targets should perhaps be 2.7e9 and 1.2e10 from VTA data?






Tony Reilly, 04/19/2024 11:32:05 Approved:

To view your pending document routing tasks, click on the link below to login to DocuShare:

https://jlabdoc.jlab.org/docushare/dsweb/routing/routing_email.jsp?url=report_base.jsp&reportType=ForApprovalCompletion&routingSlipRequestID=38616&notifyID=38627&workFlowJobName=38616
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://mailman.jlab.org/pipermail/pansophy/attachments/20240423/bf40f1c6/attachment.html>