[Pansophy] Vendor Leak Check

[John Fischer]

Hi Ashley,
We use both of them 0029 and 0033. They are for 2 different sensitivities or known for small parts and large parts.
The second page is already in a procedure template (ish) have we verified its not on the Pansophy side already. I can't remember....
JF
________________________________
From: Ashley Mitchell <ashleya at jlab.org>
Sent: Tuesday, June 10, 2025 11:09 AM
To: John Fischer <fischer at jlab.org>; Matt Weaks <weaksmc at jlab.org>
Cc: Tony Reilly <areilly at jlab.org>; pansophy <pansophy at jlab.org>
Subject: Re: Vendor Leak Check

John,

 DCG has a Rev C of 11141S0033 that was just released in April that I assumed was for vendors.  It's not clear to me which one is which of the two you sent, the scope and test reports look identical. I assume 11141S0029 is the one you're using internally?  I'm fine with the vendor one being for vendors and in DCG, but if your group is using it here, I'd prefer to turn it into a MSPR to comply with our QMS. All of our procedures for SRFOPS internal use should be controlled in Docushare, not Document Repository.  This doesn't have to be a stop everything and make the change, I know you have a lot on your plate converting L2HE documents, but it would be nice to get it converted and in Docushare in the near future.

- Ashley
________________________________
From: John Fischer <fischer at jlab.org>
Sent: Tuesday, June 10, 2025 10:53 AM
To: Ashley Mitchell <ashleya at jlab.org>; Matt Weaks <weaksmc at jlab.org>
Cc: Tony Reilly <areilly at jlab.org>; pansophy <pansophy at jlab.org>
Subject: Re: Vendor Leak Check

Ashley,
There are a couple of versions from what I remember. One that was meant for vendor packages (SOW) and one that is internal re-written by Daly and Co. See attached.
JF
________________________________
From: Ashley Mitchell <ashleya at jlab.org>
Sent: Tuesday, June 10, 2025 10:49 AM
To: Matt Weaks <weaksmc at jlab.org>; John Fischer <fischer at jlab.org>
Cc: Tony Reilly <areilly at jlab.org>; pansophy <pansophy at jlab.org>
Subject: Vendor Leak Check

Good Morning,

I noticed we're referencing/using the Vendor Standard Helium Leak Check Procedure (11141-S-0033) internally (it was referenced in AUPPS WCD Register). This should be a Master Procedure if we're using it vs sending it to a vendor to follow.  Matt or John, if you send me the word version, I can help convert it to a MSPR, it looks like the header and a bit of the wording would need to be changed for it to be used.

Thank you,

Ashley Mitchell (She/Her/Hers)
Quality Engineer
Desk: 757-269-5198
Cell: 757-434-2905
[https://www.jlab.org/div_dept/dir_off/public_affairs/logo/JLabEmailSig.png]
600 Kelvin Dr.
Suite 8, MS 55H
Newport News, VA 23606
www.jlab.org<http://www.jlab.org>

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://mailman.jlab.org/pipermail/pansophy/attachments/20250610/c07f50f3/attachment.htm>