<html>
<head>
<meta http-equiv="Content-Type" content="text/html; charset=iso-8859-1">
<style type="text/css" style="display:none;"> P {margin-top:0;margin-bottom:0;} </style>
</head>
<body dir="ltr">
<div style="font-family: Calibri, Arial, Helvetica, sans-serif; font-size: 12pt; color: rgb(0, 0, 0);">
<br>
</div>
<div>
<div style="font-family: Calibri, Arial, Helvetica, sans-serif; font-size: 12pt; color: rgb(0, 0, 0);">
<br>
</div>
<div id="appendonsend"></div>
<hr tabindex="-1" style="display:inline-block; width:98%">
<div id="divRplyFwdMsg" dir="ltr"><font style="font-size:11pt" face="Calibri, sans-serif" color="#000000"><b>From:</b> Mark Wiseman<br>
<b>Sent:</b> Thursday, July 23, 2020 5:59 AM<br>
<b>To:</b> Ed Daly <edaly@jlab.org><br>
<b>Cc:</b> Katherine Wilson <kwilson@jlab.org>; Kirk Davis <kdavis@jlab.org><br>
<b>Subject:</b> traveler list</font>
<div> </div>
</div>
<div dir="ltr">
<div style="font-family:Calibri,Arial,Helvetica,sans-serif; font-size:12pt; color:rgb(0,0,0)">
Ed</div>
<div style="font-family:Calibri,Arial,Helvetica,sans-serif; font-size:12pt; color:rgb(0,0,0)">
I have completed the column's on Author, Reviewer 1, Reviewer 2, and Project manager in the attached. I would suggest having Kirk review the cavity acceptance through cavity string assembly travelers to see if he agrees. I am not as familiar with that group
as I should be some their maybe better persons, or some maybe over committed as well. You or Katherine should do the same on the rest, though I know that group better.
<br>
</div>
<div style="font-family:Calibri,Arial,Helvetica,sans-serif; font-size:12pt; color:rgb(0,0,0)">
<br>
</div>
<div style="font-family:Calibri,Arial,Helvetica,sans-serif; font-size:12pt; color:rgb(0,0,0)">
The list looks mostly appropriate to me. <br>
</div>
<div style="font-family:Calibri,Arial,Helvetica,sans-serif; font-size:12pt; color:rgb(0,0,0)">
<ol>
<li>There was a MLI installation procedure listed under spaceframe assembly and not a corresponding one in Cold Mass Assembly and Final Assembly. Maybe this is better handled with a generic installation procedure. I know the MLI blankets are covered in the
Cold Mass Assembly, though not in detail. </li><li>There are a number of Leak Test Procedures. Again I would think generic procedures might cover this and pressure testing. Maybe these travelers just reference the generic procedures for the individual components which would be OK as well.
<br>
</li><li>I did not see one on pressure testing, but this may be covered in the Final Assembly traveler.
<br>
</li></ol>
Hope this helps.</div>
<div style="font-family:Calibri,Arial,Helvetica,sans-serif; font-size:12pt; color:rgb(0,0,0)">
Mark<br>
</div>
</div>
</div>
</body>
</html>