[Primex] hycal motion control working

[Ashot Gasparian]

    Thanks Mark,

   A good milestone on the way of preparation for
  the PrimEc-II run.

   Ashot


.............................................................
Ashot Gasparian                    Phone:(336)285-2112 (NC A&T)
Professor of Physics
Physics Department                       (757)-269-7914 JLab
NC A&T State University              Fax:(757)-269-6273 JLab
Greensboro, NC 27411               email: gasparan at jlab.org
.............................................................


On Wed, 24 Feb 2010, Mark M. Ito wrote:

> Folks,
>
> Krister and I were able to move the HyCal in the Hall today. No more
> than 1/2 inch in any direction, but motion in both directions, both
> axes. All limit switches were tested as well, by contacting them by hand.
>
>   -- Mark
>
> _______________________________________________
> Primex mailing list
> Primex at jlab.org
> https://mailman.jlab.org/mailman/listinfo/primex
>