[Primexd] [New Logentry] Overall FCal modules status during Be tgt run

[Colin Gleason]

The top left and the base in the lower middle right side of the FCAL have
HV issues. I am not sure about the others. I will check their signals
during access this week.

On Sun, Mar 3, 2019 at 12:23 AM <gasparan at jlab.org> wrote:

>
>   Hi Ilya,
>
>  Looks not bad, those few modules needs to look at.
>
>  Ashot
>
>
> >
> > Logentry Text:
> > --
> >  I checked the pi0 spectrum for all Be runs together for every FCAL
> > module,
> > excluding 3 outer layers marked grey in the attached FCAL map.
> > All modules show pi0 peaks (some of them still might be dead for a part
> of
> > the time).
> > Four modules show either meaningless spectra or have gain-factors too low
> > (investigating this),
> > marked green on the map (ids: 739, 927, 1319, 2419);
> > id 908 also looks suspicious (not marked on the map).
> >
> >
> >
> > ---
> >
> > This is a plain text email for clients that cannot display HTML.  The
> full
> > logentry can be found online at
> >
> https://logbooks.jlab.org/entry/3662284_______________________________________________
> > Primexd mailing list
> > Primexd at jlab.org
> > https://mailman.jlab.org/mailman/listinfo/primexd
> >
>
>
> _______________________________________________
> Primexd mailing list
> Primexd at jlab.org
> https://mailman.jlab.org/mailman/listinfo/primexd
>


-- 
Colin Gleason
Postdoctoral Fellow
Indiana University
Department of Physics
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://mailman.jlab.org/pipermail/primexd/attachments/20190303/5871e274/attachment-0002.html>