[Sbs_gems] [EXTERNAL] UV GEM HV Settings

[Liyanage, Nilanga K (nl8n)]

HI Sean,

No, I think it would be best to run at 3653 V  with this modified divider for right now.

We are going to study the modified divider with the  x_ray source here over the new couple of weeks. Once we know more, we can consider going higher if needed

Best

Nilanga
________________________________
From: Sbs_gems <sbs_gems-bounces at jlab.org> on behalf of Sean Jeffas <sj9ry at virginia.edu>
Sent: Thursday, November 18, 2021 3:22 PM
To: sbs_gems at jlab.org <sbs_gems at jlab.org>
Subject: [Sbs_gems] [EXTERNAL] UV GEM HV Settings

Hi Kondo and Nilanga,

After we changed the resistor on UV GEM layer 0 back in October Kondo recommended to lower the HV a bit to monitor the GEM HV. Here is the logbook reference https://logbooks.jlab.org/entry/3930480. However we discovered this week that the voltage has never been returned to 3697 V since then, and we ran all this week at 3653 V. From Kondo's log it is my impression that he meant to only set it to 3653 V for a few hours. Is it ok to change to 3697 V at this point? Also with the two other UV GEMs in BB we also have these new dividers. Then ran all night at 3653 V with cosmics with no issues. Can we set those to 3697 V as well?

Best,
Sean
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://mailman.jlab.org/pipermail/sbs_gems/attachments/20211118/9f3d0dbe/attachment-0001.html>