[Solid_hgc] how to access HGC detector

[Garth Huber]

Thanks Zhiwen for this very useful information.  We have a question for Gary:

Derek and I were looking at this engineering note yesterday, and to us it 
appears that the HGC will be suspended via rails along its outer circumference, 
and no direct contact with the cone.

1) If this is correct, does this require any changes to the HGC design you made?
2) I assume this will allow us to simplify the design of the curved plate on the 
bottom of the prototype, as we discussed last week.  Is this correct?

Regards,
Garth

> Zhiwen Zhao wrote:
> Dear All
>
> To clarify some questions about how to access HGC detector we had in
> the meeting
> yesterday, here is some info from Whit at HallA engineering
> https://hallaweb.jlab.org/wiki/index.php/SoLID_Engineering_Integration_and_CAD#Whit.27s_note_on_2016.2F02.2F26
>
> We hope to setup new meeting with HallA engineering soon to further
> address
> these questions and concerns.
> Stay tuned.


-- 
Dr. Garth Huber, Dept. of Physics, Univ. of Regina, Regina, SK S4S0A2, Canada.
tel: 1-306-585-4240. fax: 1-306-585-5659.