[Testlablcwusers] Fill MOLLER TM4 with LCW for Hydrostatic Pressure Test

[Eric Sun]

Hi Phil,

We will fill our magnet before 9:00 AM tomorrow.

Thanks a lot for the quick response.

Eric
________________________________
From: Philip Denny <denny at jlab.org>
Sent: Thursday, November 20, 2025 9:03 AM
To: Eric Sun <qsun at jlab.org>
Cc: testlablcwusers at jlab.org <testlablcwusers at jlab.org>; Probir Ghoshal <ghoshal at jlab.org>; David Kashy <kashy at jlab.org>
Subject: Re: Fill MOLLER TM4 with LCW for Hydrostatic Pressure Test

Hi Eric,

To be safe I would suggest tomorrow AM.

Phil
________________________________
From: Eric Sun <qsun at jlab.org>
Sent: Thursday, November 20, 2025 9:02 AM
To: Philip Denny <denny at jlab.org>
Cc: testlablcwusers at jlab.org <testlablcwusers at jlab.org>; Probir Ghoshal <ghoshal at jlab.org>; David Kashy <kashy at jlab.org>
Subject: Fill MOLLER TM4 with LCW for Hydrostatic Pressure Test

Hi Phil,

We were not able finish the brazing task of our TM4 magnet yesterday. As a result, we could not fill TM4 with LCW before 9:00 AM today.  However, it is likely that we will complete brazing by noon.

As I said, we need about 15-20 gallons to fill our magnet. Can we connect our magnet with LCW and fill our magnet with LCW between 12:30 PM to 2:30 PM today? If not, when can we do it?

Many thanks for the understanding.

Eric

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://mailman.jlab.org/pipermail/testlablcwusers/attachments/20251120/a0eebfc1/attachment-0001.htm>