[Clas12_rich] Mirror 5C CMM measurements

[Tyler Lemon]

Hello,

After discussion, I think that the main cause of the larger mean thicknesses of mirror 5C is where the measurement points were taken. In the Mathematica plot, we could see that the measurements for the mirror edge and the back edge made a sort of zig-zag pattern rather than a series of parallel lines. To account for this, I will fit a curve to each edge using the measurement points. The fitted curves for the mirror edge and back edge will then be used to estimate the thickness of mirror 5C. I will be out on vacation next week and will return on Tuesday July 5 so I will start the above analysis that week. At that time, I would also like to meet with Valery to look at the mock electronic panel so I can learn more about it. We could arrange a good time for this after I am back. 

Best regards,
Tyler