[Dsg-halla_magnets] PLC control of JT valve action

[Pablo Campero Rojas]

Hello Steven,

Valves controls were tested and working in remote (PLC) and local (manual control with switch) modes after debugging was done on Thursday afternoon.

I was planing on going to the Test Lab tomorrow morning since I still need to check the valve position in the voltmeter (Red Lion) monitor. I can re-check the PLC control for the valves as well.

-Pablo


________________________________
From: Dsg-halla_magnets <dsg-halla_magnets-bounces at jlab.org> on behalf of Steven Lassiter <lassiter at jlab.org>
Sent: Monday, February 21, 2022 1:38 PM
To: dsg-halla_magnets at jlab.org <dsg-halla_magnets at jlab.org>
Subject: [Dsg-halla_magnets] PLC control of JT valve action

Hello Pablo,

 When the PLC has control of the JT motors, the relays are being turned on/off when the codes sends the signal to open or close them.
The JTV1 is now opening and closing in key switch manual mode. It does not work in PLC mode.


Steven
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://mailman.jlab.org/pipermail/dsg-halla_solid/attachments/20220221/f10fd087/attachment-0002.html>