[Dsg-halla_magnets] Power supply connections

[Pablo Campero Rojas]

Hello Steven,


Mindy has finished the R-11 communication cable for the power supply and I want to start the communication test, but first  I have a few questions.

I noticed that the power on/off button in one of the two power supplies (located at the top with the current output looped/protected, see attached picture) is not latching in the "On" position. Is this something that was mentioned during the previous test performed?

Which of the two power supply will be used for the magnet low current test?
The power supply in the bottom does not have the current output plug protected, see attached picture.

Is the actual set up for the power supply safe to just plug, power on, and proceed with the communication test?


Thanks,
Pablo



-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://mailman.jlab.org/pipermail/dsg-halla_magnets/attachments/20220926/b564a1ad/attachment-0001.html>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: psu plug.jpg
Type: image/jpeg
Size: 358768 bytes
Desc: psu plug.jpg
URL: <https://mailman.jlab.org/pipermail/dsg-halla_magnets/attachments/20220926/b564a1ad/attachment-0002.jpg>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: Lakeshore power supplies.jpg
Type: image/jpeg
Size: 1416215 bytes
Desc: Lakeshore power supplies.jpg
URL: <https://mailman.jlab.org/pipermail/dsg-halla_magnets/attachments/20220926/b564a1ad/attachment-0003.jpg>