[Dsg-dc] gas cRio

[Morgan Cook]

Thanks Gents

----- Original Message -----
From: "Brian Eng" <beng at jlab.org>
To: "Morgan Cook" <mcookiv at jlab.org>
Cc: "Marc McMullen" <mcmullen at jlab.org>, "dsg-dc" <dsg-dc at jlab.org>
Sent: Tuesday, July 24, 2018 11:29:08 AM
Subject: Re: gas cRio

Found a bad ground wire for the pressure signal, Marc took the cable back to the EEL to repair it.

The pressures for the DC mixing have been increased: https://logbooks.jlab.org/entry/3581875

If it has trouble getting to 100 psi you might need to mess with the regulators.

----- Original Message -----
> From: "Morgan Cook" <mcookiv at jlab.org>
> To: "Brian Eng" <beng at jlab.org>, "Marc McMullen" <mcmullen at jlab.org>
> Cc: "dsg-dc" <dsg-dc at jlab.org>
> Sent: Tuesday, July 24, 2018 8:43:37 AM
> Subject: gas cRio

> Hi Brian and Marc,
> 
> The #1 mixing tank signal flaked out when you made the changes.  It's reading
> about 20psi high and is really noisy.
> 
> I would also like to change the mixing settings to operate between 80-100 psi
> instead of 60-80 psi.
> 
> Regards,
> Morgan