[Dsg-ft] Interlocks status

[Raffaella De Vita]

Hi Amanda,
yesterday afternoon, after we talked, I reset the chiller to the factory 
settings to see if that could help in getting the device to the setpoint 
temperature but it did not make a difference. However, this morning 
around 7:30 am, the chiller started to behave normally again and the 
temperature is now approaching the set point. We are trying to figure 
out what may have changed at the time since it looks like this sudden 
change was determined by some external factor. Was there anything done 
to the interlocks at that time?
Regards,
     Raffaella

Amanda Hoebel wrote:
> Hi Raffaella,
>
> The condensation sensor has been added into the interlocks in EPICS. We will look at the chiller and digital module to see if we can figure out why the temperature was not going to 6C.
>
> Regards,
> Amanda
> _______________________________________________
> Dsg-ft mailing list
> Dsg-ft at jlab.org
> https://mailman.jlab.org/mailman/listinfo/dsg-ft