[Dsg-hallb_magnets] Check Load cell in cRIO

[Nick Sandoval]

The cable swap was was just a test, it has been moved back. Pablo reported that one of the VI's was not an executable so I just wanted it checked.  It has not been reading since mid October so not likely.  Really to look at the VI and see what that channel is reporting.   

----- Original Message -----
From: "Brian Eng" <beng at jlab.org>
To: "Pablo Campero Rojas" <campero at jlab.org>
Cc: "dsg-hallb magnets" <dsg-hallb_magnets at jlab.org>
Sent: Friday, November 10, 2017 9:50:05 AM
Subject: Re: [Dsg-hallb_magnets] Check Load cell in cRIO

Did the LabVIEW code already get changed after the LC was moved to a different channel?

The read/write addresses need to get changed to the corresponding connector.

> On Nov 10, 2017, at 9:41 AM, Pablo Campero <campero at jlab.org> wrote:
> 
> Hi Nick,
> 
> Thanks for letting me know I'll take care of it.
> 
> Regards,
> Pablo 
> 
> From: "Nick Sandoval" <sandoval at jlab.org>
> To: "Pablo Campero Rojas" <campero at jlab.org>
> Cc: "Ruben Fair" <rfair at jlab.org>
> Sent: Thursday, November 9, 2017 3:44:18 PM
> Subject: Check Load cell in cRIO
> 
> Hi Pablo,
> 
> We have a non-responsive load cell and suspect it may be in LV chassis or scaling. 
> 
> Can you please confirm the scaling and report back what the LV is seeing for this channel?  
> 
> https://logbooks.jlab.org/entry/3492001
> 
> Thanks,
> 
> Nick

_______________________________________________
Dsg-hallb_magnets mailing list
Dsg-hallb_magnets at jlab.org
https://mailman.jlab.org/mailman/listinfo/dsg-hallb_magnets