[Dsg-mvt] MVT cables

[Marc McMullen]

Hi Matt,

The sketch looks good, I would add the following changes:

Run the MFC Comms to the same area as the MFC power and PT cables on 
SFL3-south. I spoke with Brent yesterday and he said he can put a switch 
there.

Brent,

Please respond if I am incorrect.

Thanks,

Marc


On 10/17/2017 12:14 PM, Matthew Marchlik wrote:
> Marc,
>
> You mentioned you would provide a sketch before, but I know you're swamped with RICH. I started one since I will run or have someone run the cabling. Please edit the attached diagram as you see fit and get it back to me as soon as possible. Once I have the cat5 in hand I will try to get everything run.
>
> Thanks,
> Matt
>
> ----- Original Message -----
> From: "Marc McMullen" <mcmullen at jlab.org>
> To: "Matthew Marchlik" <marchlik at jlab.org>
> Sent: Tuesday, October 17, 2017 11:58:49 AM
> Subject: Re: MVT cables
>
> Hi Matt,
>
> The MFC power cables and the PT power/signal cables are the same (3
> cond, 22awg). So 3 runs of 3 should give 2 spare cables. (5 MFCs, 2 Pt).
>
> These two spare can be used for MFC Temp/Humidity if not need for PT or
> MFC power.
>
> The MFC communication cable is the network I ordered yesterday. 2 runs
> of 3 should give 1 spare.
>
> Marc
>
>
>
> On 10/17/2017 11:53 AM, Matthew Marchlik wrote:
>> Hi Marc,
>>
>> What is the cable type for the PT signal? Same as power cable?
>>
>> What is the cable type for the MFC temperature signal?
>>
>> Matt

-- 
Marc McMullen
Detector Support Group
757-269-7738