[Dsg-mvt] MVT OSP for EEL Operations

[Brian Eng]

Hi Bob,

Sure we can try that, what time is good today? I'd rather get it done sooner rather than later.

I'm assuming someone from Hall B Engineering will be available? If not could you let us know which valves need to be manipulated to get the gas to the test line?

> On Jan 27, 2020, at 8:22 AM, Bob Miller <rmiller at jlab.org> wrote:
> 
> Hi Marc,
> 
> FMT will be used for Bonus from Feb - May.  It will use the 3 gas mixing system on the gas pad to supply gas to the Hall, to the FMT.
> 
> It would be good to test this system today or tomorrow, and send the gas to the test line outside of the gas pad.  Are you or Brian available to test the system?
> 
> Regards,
> Bob
> From: Marc Mcmullen <mcmullen at jlab.org>
> Sent: Friday, January 24, 2020 12:05 PM
> To: Bob Miller <rmiller at jlab.org>; Bert Manzlak <manzlak at jlab.org>
> Cc: Yuri Gotra <gotra at jlab.org>
> Subject: MVT OSP for EEL Operations
>  
> Hi Bob and Bert,
> 
> I am just covering the bases. I am assuming that MVT will use premix bottles on the gas pad behind the EEL. The OSP presented states "It also brings information concerning the validation for pressurized system and flammable gas which were not done for the TOSP describing the commissioning in the Hall of the MVT with premix bottles". I am just checking that the connection to the gas fittings going into the penetration have been considered/calculated with all the required components for pressure and flammable gas. 
> 
> Assuming Bob is the system owner and everything has been reviewed, I'm good.
> 
> Marc