[Dsg-rich] redundant humidity sensors wired to cRIO

[Tyler Lemon]

Hello, 

Also, the Hardware Interlock LabVIEW program has been updated with the correct calibration constants. 

Best regards, 
Tyler 


From: "Tyler Lemon" <tlemon at jlab.org> 
To: "dsg-rich" <dsg-rich at jlab.org> 
Sent: Monday, December 4, 2017 5:00:23 PM 
Subject: [Dsg-rich] redundant humidity sensors wired to cRIO 

Hello, 

At Marco's request, all humidity sensors for the electronic panel have been removed and the redundant sensors for the nitrogen volume wired to the cRIO in their place. 

Until this afternoon, the redundant sensors at each location were not read. 

The table below shows the nitrogen volume sensors (#9- #15) and which humidity sensors numbers correspond to the newly wired redundant sensors on the sensors boards (#1 - #8). 

Humidity # 
	Redundant Sensor Humidity #: 

9 	1 

10 
	3 

11 
	4 

12 
	5 

13 
	6 

14 
	7 

15 
	8 


Best regards, 
Tyler 

_______________________________________________ 
Dsg-rich mailing list 
Dsg-rich at jlab.org 
https://mailman.jlab.org/mailman/listinfo/dsg-rich 
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://mailman.jlab.org/pipermail/dsg-hallb_rich/attachments/20171204/fb488fd5/attachment-0002.html>