[Dsg-rich] dual interlock chassis installed in EEL 124

[Marco Mirazita]

Hi Tyler,
just to be sure before we start, where I find the humidity and 
temperature sensors 3,5,7 that are installed in the electronic panel?
In the "Sector 1 nitrogen panel interlocks"  or in the "Sector 1 
electronic panel interlocks"?
Thank you
Marco


Il 2017-12-08 17:48 Tyler Lemon ha scritto:
> Hello,
> 
> The second interlock cRIO chassis has been installed in EEL 124.
> 
> All interlock sensors that are not epoxied into RICH are read by this
> chassis. Any sensor placed into the electronic panel will be read by
> the second chassis.
> 
> The labels on the cables and what sensors they read for the second
> interlock chassis are:
> 
> Label on cable, T1, T2, H1, H2
> 
> 1, Temperature #1, Temperature #2, Humidity #1, Humidity #2
> 
> 2, Temperature #3, Temperature #4, Humidity #3, Humidity #4
> 
> 3, Temperature #5, Temperature #6, Humidity #5, Humidity #6
> 
> 4, Temperature #7, Temperature #8, Humidity #7, Humidity #8
> 
> 5, Temperature #9, Temperature #10, Humidity #9, Humidity #10
> 
> 6, Temperature #11, Temperature #12, Humidity #11, Humidity #12
> 
> 7, Temperature #13, Temperature #14, Humidity #13, Humidity #14
> 
> 8, Temperature #15, Temperature #16, Humidity #15, Humidity #16
> 
> In the nitrogen panel cRIO, the temperature sensors connected
> correspond to the same numbering scheme as the humidity sensors.
> 
> I was not able to add the calibration constants for any of the
> electronic panel humidity sensors. I will add them on Monday.
> 
> To get the wiring for the relays that disable the CAEN, I had to
> remove the override switch's wiring as the ferrules were too large to
> accommodate the new wiring for the second cRIO. I will also rewire
> this on Monday.
> 
> Best regards,
> 
> Tyler
> 
> _______________________________________________
> Dsg-rich mailing list
> Dsg-rich at jlab.org
> https://mailman.jlab.org/mailman/listinfo/dsg-rich