[Dsg-rich] Fwd: Request for Quote

[Marc McMullen]

Hi Ed,

A week should be fine, the sooner the better. FYI when you are considering the fabrication there is some flexibility that can be afforded in manufacturing if it will control the cost. So please feel free to suggest any money saving ideas.

Thanks,
Marc


On 3/23/2017 4:04 PM, Ed Bonnema wrote:
> Marc
> When would you like a quote by?
> Thanks
> Ed
>
> Edward C.  Bonnema
> Vice President, Operations
> Meyer Tool & Manufacturing, Inc.
> Specialists in Cryogenic, Vacuum & Pressure Technology
> 4601 W. Southwest Hwy.
> Oak Lawn, Illinois 60453
>
> Ph:  708-425-9080
> Fax: 708-425-2612
>
> Website:  www.mtm-inc.com
> -----Original Message-----
> From: Marc McMullen [mailto:mcmullen at jlab.org]
> Sent: Thursday, March 23, 2017 2:29 PM
> To: sales at mtm-inc.com
> Cc: dsg-rich <dsg-rich at jlab.org>
> Subject: [Dsg-rich] Fwd: Request for Quote
>
> Hi Randy,
>
> My name is Marc McMullen, the Sr. Designer for the Physics Department Detector Support Group at Jefferson Lab in Newport News, VA.  Our collaborator, INFN (a national lab from Italy), is seeking a quote for fabrication of an assembly which will be used for materials handling purposes for the RICH Particle detector to be used at the JLab CLAS 12 particle detector. I have attached the designs to this email  for your consideration. Please reply all to this email with your quotes or any additional questions to receive a prompt response.
>
> Just as a note the final assembly will use swivel eye bolts, which you need not add to the fabricated parts or quotation.
>
> The drawing uses metric components please feel free to use the closest imperial standard size for the quote and any other suggestions which control the cost will be considered.
>
> Please itemize where possible.
>
>
> Regards,
>
>
> --
> Marc McMullen
> Detector Support Group
> 757-269-7738
>
>
>
>
>
>

-- 
Marc McMullen
Detector Support Group
757-269-7738