[Dsg-rich] Purchase

[Dario Orecchini]

Hi Marc,
We have the right tap M5 (by hand) so there’s no problems.
In any case the pitch is 0.8.

Bue
Dario

Inviato da iPhone

> Il giorno 07 nov 2017, alle ore 07:26, Marc McMullen <mcmullen at jlab.org> ha scritto:
> 
> Good Morning Dario,
> 
> In the drawing you list two new holes as M5, is that course of fine pitch?
> 
> Thanks,
> 
> Marc
> 
> 
>> On 11/6/2017 7:09 PM, Dario Orecchini wrote:
>> Hi Marc,
>> you should buy for the E_Panel Cooling System the following stuff from McMaster Carr:
>> 
>> - 3177T120_SNUG-FIT VIBRATION-DAMPING LOOP CLAMP    >(ID ½”) N. 2 PACKS OF 5
>> - 91287A125_18-8 STAINLESS STEEL HEX HEAD CAP SCREW >(M5x20) N. 1 PACK
>> - 91828A241_TYPE 18-8 STAINLESS STEEL HEX NUT       >(NUT M5) N.1 PACK
>> 
>> Moreover, attached you will find the drawing necessary to prepare the two Stainless Steel pipes as air manifold.
>> We can discuss about it when you have time.
>> 
>> Thanks
>> Dario
>> 
>> 
> 
> -- 
> Marc McMullen
> Detector Support Group
> 757-269-7738
>