[Dsg-rich] cable for RICH moisture sensor

[Tyler Lemon]

Hi George, 

The cable is ready to go. 

The connector was attached and tested on the development cRIO downstairs. Pablo and I ran the cable this morning from the cRIO rack to the floor. We left the end of the moisture transducer's cable with the connector near the RICH bubblers since we could not reach to follow route the other RICH cables take to the patch panel. 

We talked with Denny in the hall and verified that the Genie lift is in a location that can access the patch panel and exhaust line to install the transducer. 

Best regards, 
Tyler 


From: "George Jacobs" <jacobsg at jlab.org> 
To: "Tyler Lemon" <tlemon at jlab.org>, "dsg-rich" <dsg-rich at jlab.org> 
Sent: Monday, July 30, 2018 11:01:29 AM 
Subject: cable for RICH moisture sensor 

Hi Tyler, 

Is the cable for the 0-3000 ppm H2O transducer ready to connect? or does it need to have the connector attached and then be run? 

George 
-- 
George Jacobs
Jefferson Lab (TJNAF)
STE 12
12000 Jefferson Ave.
Newport News, VA 23606

(office) 757-269-7021

(cell)   757-876-0480

(email) jacobsg at jlab.org (website) https://userweb.jlab.org/~jacobsg 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://mailman.jlab.org/pipermail/dsg-hallb_rich/attachments/20180730/50d6f645/attachment-0002.html>