[dsg-hallb_rich] new dry cabinet assembled and moved into EEL 124

[Tyler Lemon]

Valery,

I did not get to the EP prototype. I'll most likely have to go in sometime soon again for magnet interlock checks and to drop off sensors for RICH interlock PCB fabrication, so I'll look for it then.

-Tyler
________________________________
From: Valery Kubarovsky <vpk at jlab.org>
Sent: Monday, May 3, 2021 9:14 PM
To: Tyler Lemon <tlemon at jlab.org>; dsg-hallb_rich at jlab.org <dsg-hallb_rich at jlab.org>
Subject: Re: new dry cabinet assembled and moved into EEL 124

Hi Tyler,
Thanks a lot!
Did you by chance find the small prototype of the electronic panel that Marco M requested to send him back to Italy?
Thanks,
Valery


________________________________
From: dsg-hallb_rich <dsg-hallb_rich-bounces at jlab.org> on behalf of Tyler Lemon <tlemon at jlab.org>
Sent: Monday, May 3, 2021 20:50
To: dsg-hallb_rich at jlab.org <dsg-hallb_rich at jlab.org>
Subject: [dsg-hallb_rich] new dry cabinet assembled and moved into EEL 124

Hello,

The new dry cabinet has been completely assembled and moved in to EEL 124. Photos of the cabinet in the clean room are attached.

To make room for the new dry cabinet, I rearranged the wheeled cabinets to the left of it in the photo named "area of EEL 124 with dry cabinet". No cabinets are blocking any vent and there are no items in the the "keep out" area around the circuit breaker panel and fire extinguisher in the back left corner of the photo.

Also attached for general reference is the "certificate of calibration" for the cabinet from Super Dry.

-Tyler
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://mailman.jlab.org/pipermail/dsg-hallb_rich/attachments/20210504/8b053908/attachment-0001.html>