[Dsg-rtpc] RTDs

[Brian Eng]

The ones Marc just ordered (a 5 pack) have a fiberglass instead of PFA insulation.

The PFA one requires extra preparation in order for the glue to properly adhere to it.

So if these are all intended to go through a fitting and be glued in then I'd suggest using the new ones for all of sensors.

Also this is significantly more RTDs than was planned for so we'll have to shuffle some cRIO modules around in order to accommodate this new setup.



Is there a drawing that has where these RTDs are located and also what they're numbered?

--
Brian Eng
Detector Support Group
757-269-6018

> On Nov 1, 2019, at 2:56 PM, Carlos Ayerbe Gayoso <gayoso at jlab.org> wrote:
> 
> Hi again Marc
> 
> Bryan told me that the new ones will have different body, which will be easy to glue. In that case, do you suggest to change all? 
> 
> Cheers
> 
> -Carlos
> From: Dsg-rtpc <dsg-rtpc-bounces at jlab.org> on behalf of Marc Mcmullen <mcmullen at jlab.org>
> Sent: Friday, November 1, 2019 2:44 PM
> To: dsg-rtpc at jlab.org <dsg-rtpc at jlab.org>
> Subject: [Dsg-rtpc] RTDs
>  
> Hi Carlos,
> 
> How many RTDs did you need to install?
> 
> Marc