[dsg-svt] ambient sensor boards

[Brian Eng]

Okay, they'll be tested today.

The integration with CSS will need coordination with Nathan.
I suspect we won't get to it until after we upgrade the patch panels.

----- Original Message -----
> From: "Yuri Gotra" <gotra at jlab.org>
> To: "dsg-svt" <dsg-svt at jlab.org>
> Sent: Wednesday, May 16, 2018 8:44:34 AM
> Subject: Re: [dsg-svt] ambient sensor boards

> Brian,
> 
> Stephan inserted the sensor boards to MVT yesterday, could you please
> connect the cables and check the readings. We would need the values to
> be added to the CSS too. Thank you
> 
> 
> On 5/15/18 3:54 PM, Brian Eng wrote:
>> Yuri,
>>
>> The assemblies are complete and tested.
>>
>> They're labeled A,B,C at both ends if you want to keep track of where they get
>> installed.
>>
>> I put them on top of the MVT wooden crate in EEL/125.
>>
>> !!! IMPORTANT !!!
>> Note that there is still tape on top of the humidity sensors that needs to be
>> removed prior to installation. It ships with that installed to protect the
>> sensors from being saturated, so best to remove it once they're down in the
>> Hall.
>>
>> They will be tested after installation and re-terminated with connectors once
>> the patch panel work starts.
>>
>> --
>> Brian Eng
>> Detector Support Group
>> 757-269-6018
>>
>>> On May 14, 2018, at 12:06 PM, Yuri Gotra <gotra at jlab.org> wrote:
>>>
>>> MVT is going to be opened today. Please provide the ambient temperature sensor
>>> boards, cables ~5 meters long to mount inside the BMT tomorrow. Thank you
>>>
> 
> 
> _______________________________________________
> dsg-svt mailing list
> dsg-svt at jlab.org
> https://mailman.jlab.org/mailman/listinfo/dsg-svt