[dsg-hallb_svt] CVT work

[Brian Eng]

Yes, I'll be in tonight to start work on connecting cables on the detector side.

Two quick questions.
1) How neatly do these need to be run, i.e. can I just use velcro/tape to secure cables or should it be properly cable wrapped/routed?
2) Has anything been decided on the damaged HV patch panel connector?

________________________________
From: Yuri Gotra <gotra at jlab.org>
Sent: Friday, April 9, 2021 8:06 AM
To: Brian Eng <beng at jlab.org>
Cc: dsg-hallb_svt at jlab.org <dsg-hallb_svt at jlab.org>
Subject: Re: CVT work


Hello Brian,

The cooling system has been fixed, could you please help us connect the cables on detector side? Thank you


On 4/6/21 2:44 AM, Brian Eng wrote:
The iseg HV card to patch panel cable can't be fixed (at least not quickly and we don't have the parts) so I replaced it with a spare cable.

Both of the HV patch panel to detector cables that had pins pushed in were fixed. However, the pin on the R1M10 on the front of the patch panel is damaged and it looks like there's debris in it as well. The quickest fix would be to just use the next connector down, but I don't know how easy that change is to make in software. Maybe using the old R4 HV patch panel box instead?

The slow control cables between the VME crate and patch panel were connected and the coolant temperature sensor cable to the patch panel was repaired (but I couldn't find a heat gun for the heat shrink so it temporarily has tape on it too).

Networking was run for the slow controls VME crate, the DAQ crate that has both the controller and power supply (the other is missing both), and all the MPOD modules.

I started to run cabling for the HTSB sensors in the detector but there is still some coolant lines that need to be insulated and/or connected so I didn't want to undo the HFCB disconnects that have been folded back. The insulation needs to be repaired prior to connecting any of the detector cables since once the structure that holds the L1C is installed that part will be very difficult to access.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://mailman.jlab.org/pipermail/dsg-hallb_svt/attachments/20210409/441f03ab/attachment.html>