[Dsg-hallc_controls] Fw: Hall C NPS cable work for DSG
bonneau at jlab.org
Wed Oct 30 09:49:07 EDT 2019
Thank you for your reply Jack.
When the remaining parts needed for the work arrive, let us know and we'll meet and talk about the fabrication of the NPS cables and the new due date for the project.
From: Jack Segal <segal at jlab.org>
Sent: Tuesday, October 29, 2019 4:56 PM
To: Brad Sawatzky
Cc: Peter Bonneau; dsg-hallc_controls at jlab.org; Patrizia Rossi
Subject: Re: [Dsg-hallc_controls] Hall C NPS cable work for DSG
Fischer. The pin is a solder and the braid is a clamp.
On 10/29/2019 4:53 PM, Brad Sawatzky wrote:
> If we are still going with the Radiall connector (last information I
> had), then I also have set of HV crimp tools and a few connectors that
> arrived from the Glasgow group last week.
> -- Brad
> On Tue, 29 Oct 2019, Jack Segal wrote:
>> Thanks for the reminder. I have not heard of anything new. I was reminded to order the RG174/U cable. Just did. 2000 ft. in stock.
>> Should be in soon. I have the Molex connector and crimp tools on hand. I have the SMA connector on hand. The HV connector is past
>> due and I asked Jami to check on it. The example cable is on my desk in the EEL. I can bring it down and we can talk about how you
>> folks want to proceed at this point. I have not tried to assemble one of these.
>> On 10/29/2019 12:47 PM, Peter Bonneau wrote:
>>> Hi Jack,
>>> We understand there is a delay for the NPS work in Hall C.
>>> If you could keep us in the loop regarding the new due date for this project, we'll be able to schedule the NPS cabling work in with our other DSG projects.
Halls A and C Spectrometer Support Manager
Thomas Jefferson National Accelerator Facility
12000 Jefferson Avenue
Newport News, VA 23606-4486
Phone: (757) 269-7242
Cell: (757) 320-9977
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the Dsg-hallc_controls