[Dsg-hallc_nps] [EXTERNAL] Re: DSG testing of NPS humidity sensors

[Brad Sawatzky]

Hi folks,

If possible, it would be good for someone from the DSG to drop by
EEL/108 Friday at 1pm to take a look at what has been completed and make
sure we are on the same page here.  Emmanuel and I were planning to meet
at that time already.

There were some prior questions about getting power to the humidity
sensors.  It sounds like that detail was missed and needs to be
addressed as well:
  - What is the expected current draw?
  - Is it feasible to use 3.5V?  We have that available in the detector
    already.
  - Can the power be supplied on the same multi-conductor cables used
    for the thermocouple/humidity sensor readout?

-- Brad

On Thu, 29 Sep 2022, Peter Bonneau wrote:

> Hey Guys,
> The NPS humidity sensors should be fully tested before installation.
> This includes testing with the cable and power supply used in installation
> and readout via Keysight DAQ.

-- 
Brad Sawatzky (he/him), PhD <brads at jlab.org> -<>- Jefferson Lab/SciComp/F272
Ph: 757-269-5947  -<>-  Fax: 757-269-5235  -<>- Pager: brads-page at jlab.org
The most exciting phrase to hear in science, the one that heralds new
  discoveries, is not "Eureka!" but "That's funny..."   -- Isaac Asimov