[Halld-jlab] Cabling Issues

[Alexander Somov]

Hi Fernando,

We'll label and see how to route the trigger fibers 
from master TIs in a better way during next week
(we didn't want to bend the trigger fibers much).

Cheers,
        Alex



On Fri, 17 Jan 2014, Fernando J Barbosa wrote:

> Hi all,
>
> Some network and trigger cabling in the hall has been installed and used on a 
> temporary basis without much regard to routing or labeling, which is 
> understandable. Such phase of activities will end within the next two weeks. 
> So, on February 1st, we will start removing any cables that are not properly 
> labeled; routing will be properly done so expect interruptions. As you know, 
> labeling is geographical (refer to GlueX-doc-1452). The attached photos 
> illustrate some of the concerns:
>
> photo1: no labels
> photo2: no labels; network cables (dark blue) should come from the left side 
> vertical cable manager, not the bottom (horizontal cable manager); trigger 
> fiber (light blue) needs to be routed via horizontal and vertical cable 
> managers (use the opening on the right, adjacent, on vertical cable manager).
> photo3: trigger fibers, again the same issue as above, no labels.
> photo4: these unconnected cables (come from ROC, see photo2), located inside 
> one of the vertical cable managers, present a potential safety issue and the 
> black wire tie is the icing on the cake.
>
> If you have any questions, please ask. We will help with labeling, routing if 
> you prefer - just provide a list of labels.
>
> Thanks for your attention and best regards,
> Fernando
>