[Halld-level1] Electrical-->Optical and Optical-->Electrical converter modules

[Serguei Pozdniakov]

We got a success with VME Optical modules (FCAL->TS):

I swapped 6 optical cables on the Trigger side, and got signals from 
FCAL pulser output and cosmic output.

Now optical cable #12 connected to optical input #1 of 
Optical-->Electrical module in TS-TD crate,
optical cable #11 connected to optical input #2, optical cable #10 
connected to optical input #3 and so on..

FCAL pulser connected to TS TRGIN B1 input
FCAL cosmic connected to TS TRGIN B2 input.

Instead of real cosmic, now B2 is obtaining signals from NIM pulse 
generator from FCAL side.
I did it to let Alex Somov do a check TS configuration with active TRGIN 
B2 input.

Regards, Serguei P.





On 6/19/14 4:00 PM, Chris Cuevas wrote:
> I installed an Electrical->Optical (EO) module into the TOF crate.
> (D2-1-TOP; slot#20).  There are six ST style fiber connectors plugged
> into each of the optical output ports and short coaxial cables are
> installed for the input ports.  The inputs are configured to accept a
> standard NIM level.
>
> The Optical-->Electrical (OE) module is installed in the TS-TD crate.
> (U14-Top; slot#20).   Six ST style fiber connectors are plugged into
> each of the optical inputs and I will need to install short coaxial
> adapter cables so the NIM signals can be connected to a NIM-->ECL converter.
>
> As soon as the Tagger crates are installed we can place a EO module in
> one of the crates closest to the Tagger tunnel trigger fiber optic patch
> panel and use the optical trunk lines to transport any signals needed
> for diagnostics etc to the Hall D Trigger rack.
>
> -Chris
> ~~~~~~~~~~~~~
>
> _______________________________________________
> Halld-level1 mailing list
> Halld-level1 at jlab.org
> https://mailman.jlab.org/mailman/listinfo/halld-level1