[Halld-pid-upgrade] Meeting tomorrow? and Re: Confirming the Horizontal Orientation

[Justin Stevens]

Hi All,

Sounds like we've made an official orientation decision, for the prototype at least.  

The plan from last time was to have a meeting tomorrow (Friday) at 1:30.  Since it's only a week after the collaboration meeting I'm not sure we have much to discuss.  Are there items to discuss tomorrow, or should we wait another week?  If I don't hear back before noon tomorrow I'll assume we can postpone until next week.

Thanks,
Justin

On May 21, 2015, at 1:41 PM, John Hardin wrote:

> Ok, then I will tell them to go that way as well.  We'll have time to talk about this next week too, I suppose.
> 
> John
> 
> On Wed, May 20, 2015 at 6:13 PM, Shepherd, Matthew <mashephe at indiana.edu> wrote:
> 
> I think the horizontal orientation is the way to go.
> 
> John Frye is working on conceptual designs for that.
> 
> Matt
> 
> ---------------------------------------------------------------------
> Matthew Shepherd, Associate Professor
> Department of Physics, Indiana University, Swain West 265
> 727 East Third Street, Bloomington, IN 47405
> 
> Office Phone:  +1 812 856 5808
> 
> > On May 19, 2015, at 9:10 PM, Justin Stevens <jrsteven at jlab.org> wrote:
> >
> > Please see the message below from John asking for confirmation that we've decided to use the horizontal bar orientation for the prototype box design.  If someone sees a problem with this please send a note to the list.
> > -Justin
> >
> > PS. There may be an issue with the mailing list (John's post to the list failed earlier) so let me know if you see similar problems.
> >
> > ---------- Forwarded message ----------
> > From: John Hardin <jmhardin at mit.edu>
> > Date: Tue, May 19, 2015 at 5:57 PM
> > Subject: Confirming the Horizontal Orientation
> > To: Halld-pid-upgrade at jlab.org
> >
> >
> > Hello all,
> >     Bates is at a stage where they need to finalize whether we are using a horizontal or vertical orientation for the bars (the engineering of the seals is different enough that it shouldn't be done in parallel).  Mike and I are of the opinion that we should  finalize the prototype as being horizontal, is there any reason I should tell them otherwise?
> >
> > Thank you,
> > John
> > _______________________________________________
> > Halld-pid-upgrade mailing list
> > Halld-pid-upgrade at jlab.org
> > https://mailman.jlab.org/mailman/listinfo/halld-pid-upgrade
> 
> 
> _______________________________________________
> Halld-pid-upgrade mailing list
> Halld-pid-upgrade at jlab.org
> https://mailman.jlab.org/mailman/listinfo/halld-pid-upgrade
> 
> _______________________________________________
> Halld-pid-upgrade mailing list
> Halld-pid-upgrade at jlab.org
> https://mailman.jlab.org/mailman/listinfo/halld-pid-upgrade