[Halld-pid] Fwd: EJ- scintillator

[eugenio at fsu.edu]

Dear Tim & Chuck,

The manufacturer of the TOF scintillator bars is asking if we can get by with about a dozen of the long bars which are shorter by an 1/8".   

I briefly discussed this with Ian Winger and Randal Smith at FSU, and  since this would amount to 1/16" short on each side, it does not seem like a problem.   I would like JLab confirmation and approval(or not) before responding.   Do we have the flexibility in the TOF frame design to accommodate there request?   Or should we insist on receiving the specification length?


--
Prof. Paul Eugenio
Florida State University
Department of Physics
Tallahassee, Florida,  USA 32306

(850) 325-0314
eugenio at fsu.edu



>> 
>>> Hello Paul,
>>> On the 76 ea. 254cm bars, how critical is your length? We have about 9-12 pieces that are approx. 0.125" too short.  Can you use them?
>>> Regards,
>>> Chris
>>>  ____________________________________________________
>>> Chris Maxwell
>>> Sales Manager
>>> 
>>> Eljen Technology
>>> 1300 W. Broadway
>>> Sweetwater TX 79556

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://mailman.jlab.org/pipermail/halld-pid/attachments/20130116/6c42717f/attachment-0002.html>