[Halld-pid] Fwd: EJ- scintillator

[Beni Zihlmann]

Hi Eugenio,

at first sight I think this should not be a problem. However if it is 
possible I would then try to make the light
guides for those paddles 1/16" longer at the strait section. Then there 
would be no difference at all in the
mounting section.

my half cent ;-)

cheers,
Beni

> Dear Tim & Chuck,
>
> The manufacturer of the TOF scintillator bars is asking if we can get 
> by with about a dozen of the long bars which are shorter by an 1/8".
>
> I briefly discussed this with Ian Winger and Randal Smith at FSU, and 
>  since this would amount to 1/16" short on each side, it does not seem 
> like a problem.   I would like JLab confirmation and approval(or not) 
> before responding.   Do we have the flexibility in the TOF frame 
> design to accommodate there request?   Or should we insist on 
> receiving the specification length?
>
>
> --
> Prof. Paul Eugenio
> Florida State University
> Department of Physics
> Tallahassee, Florida,  USA 32306
>
> (850) 325-0314
> eugenio at fsu.edu <mailto:eugenio at fsu.edu>
>
>
>
>>>
>>>> Hello Paul,
>>>> On the 76 ea. 254cm bars, how critical is your length? We have 
>>>> about 9-12 pieces that are approx. 0.125" too short.  Can you use them?
>>>> Regards,
>>>> Chris
>>>> ____________________________________________________
>>>> Chris Maxwell
>>>> Sales Manager
>>>>
>>>> Eljen Technology
>>>> 1300 W. Broadway
>>>> Sweetwater TX 79556
>
>
>
> _______________________________________________
> Halld-pid mailing list
> Halld-pid at jlab.org
> https://mailman.jlab.org/mailman/listinfo/halld-pid

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://mailman.jlab.org/pipermail/halld-pid/attachments/20130116/2ef21282/attachment-0002.html>