[Halld-tracking-hw] End plates

[Curtis A. Meyer]

Wednesday at 10:30am sounds great -- c urtis
Tim Whitlatch wrote:
> How about Wednesday at 10:30 am?
>
> Curtis A. Meyer wrote:
>> Friday at 10:30am works. The question is do we want to have the 
>> discussion
>> sooner? We clearly want the holes drilled by the vendor, and my take 
>> is that
>> given that people have considered what was bounced around over the 
>> last two
>> weeks, the only one who can really say what will work is Slava. The 
>> plate is
>> really too busy for the rest of us to know about this.
>>
>>  My take is that we need the grounding holes and some additional 
>> holes for
>> standoffs. As long as those are placed, then we should be good.
>>
>>  As per earlier dates, tomorrow does not work for me, but most of 
>> Wednesday
>> from 10:00am till 3:00pm works. Thursday is good after 1:30pm for me.
>>
>>   Curtis
>>
>> Tim Whitlatch wrote:
>>> Hi All,
>>>
>>> The vendor is getting ready to start the machining of the end plate 
>>> soon. We have about a week to decide on the holes for the grounding 
>>> scheme if we wish the vendor to get it in now. We can of course do 
>>> it later but it would be more cost effective to do it now. Shall we 
>>> discuss this Friday at 10:30am?
>>>
>>> Cheers,
>>>
>>>        Tim
>>> _______________________________________________
>>> Halld-tracking-hw mailing list
>>> Halld-tracking-hw at jlab.org
>>> https://mailman.jlab.org/mailman/listinfo/halld-tracking-hw
>>>
>>>   
>>
>>
>


-- 
Prof. Curtis A. Meyer		Department of Physics
Phone:	(412) 268-2745		Carnegie Mellon University
Fax:	(412) 681-0648		Pittsburgh PA 15213-3890 
cmeyer at ernest.phys.cmu.edu	http://www.curtismeyer.com/