[Halld-tracking-hw] End plates

[Tim Whitlatch]

How about Wednesday at 10:30 am?

Curtis A. Meyer wrote:
> Friday at 10:30am works. The question is do we want to have the 
> discussion
> sooner? We clearly want the holes drilled by the vendor, and my take 
> is that
> given that people have considered what was bounced around over the 
> last two
> weeks, the only one who can really say what will work is Slava. The 
> plate is
> really too busy for the rest of us to know about this.
>
>  My take is that we need the grounding holes and some additional holes 
> for
> standoffs. As long as those are placed, then we should be good.
>
>  As per earlier dates, tomorrow does not work for me, but most of 
> Wednesday
> from 10:00am till 3:00pm works. Thursday is good after 1:30pm for me.
>
>   Curtis
>
> Tim Whitlatch wrote:
>> Hi All,
>>
>> The vendor is getting ready to start the machining of the end plate 
>> soon. We have about a week to decide on the holes for the grounding 
>> scheme if we wish the vendor to get it in now. We can of course do it 
>> later but it would be more cost effective to do it now. Shall we 
>> discuss this Friday at 10:30am?
>>
>> Cheers,
>>
>>        Tim
>> _______________________________________________
>> Halld-tracking-hw mailing list
>> Halld-tracking-hw at jlab.org
>> https://mailman.jlab.org/mailman/listinfo/halld-tracking-hw
>>
>>   
>
>