[Halld-tracking-hw] New preamp - resending table

[Gerard Visser]

Hi all,
	Well, small correction to the below is that the ADC125 channels are actually 
labelled 0-71 (i.e. 0-23 on one connector, then 24-47 and 48-71. At least on the 
documentation and currently in the readout data. The latter is just firmware and 
could be modified. However I would argue that it is better to start from 0 so 
that channel numbers are directly useful as indices.

	Gerard

Fernando J. Barbosa wrote:
> Hi Yves,
> 
> Just for clarification, the new cable should have a one-to-one 
> correspondence to the new preamp and the fADC125. This is HVB chs 24-1 
> map into new cable chs 1-24 which map into fADC125 chs 1-24. I will 
> re-label the new HVB chs 1-24 as well.
> 
> Best regards,
> Fernando