[Halld-tracking-hw] New preamp - resending table

[Fernando J. Barbosa]

Hi Gerard,

Thanks for the reminder. We have adopted the convention of numbering all 
readout electronics starting with channel 0.

Best regards,
Fernando



Gerard Visser wrote:
> Hi all,
>     Well, small correction to the below is that the ADC125 channels 
> are actually labelled 0-71 (i.e. 0-23 on one connector, then 24-47 and 
> 48-71. At least on the documentation and currently in the readout 
> data. The latter is just firmware and could be modified. However I 
> would argue that it is better to start from 0 so that channel numbers 
> are directly useful as indices.
>
>     Gerard
>
> Fernando J. Barbosa wrote:
>> Hi Yves,
>>
>> Just for clarification, the new cable should have a one-to-one 
>> correspondence to the new preamp and the fADC125. This is HVB chs 
>> 24-1 map into new cable chs 1-24 which map into fADC125 chs 1-24. I 
>> will re-label the new HVB chs 1-24 as well.
>>
>> Best regards,
>> Fernando
-------------- next part --------------
A non-text attachment was scrubbed...
Name: barbosa.vcf
Type: text/x-vcard
Size: 188 bytes
Desc: not available
Url : https://mailman.jlab.org/pipermail/halld-tracking-hw/attachments/20100409/ec3e011a/attachment.vcf