[Solid_ec] MaPMT Pre-Amp

[Xiaochao Zheng]

Hi Zhihong:

We already had a meeting with the detector group yesterday and we will have another one today.

Xiaochao

----- Original Message -----
From: "Zhihong Ye" <yez at jlab.org>
To: "solid ec" <solid_ec at jlab.org>
Sent: Friday, April 18, 2014 10:03:59 AM
Subject: [Solid_ec] MaPMT Pre-Amp

The JLab detector group has two designs of the MaPMT pre-amps. I had a 
look at Wenze Xi's design, which combines the 64 channels into 8(x) x 
8(y) array outputs. These 16 output channels are amplified and read out 
by a 16-pin ribbin cable, and a sum-signal of all these channels is also 
available for other purpose, like triggering. Wenze told me that in 
2006, to build such a pre-amps cost him $500. It might be cheaper now.

The detector group is willing to help us to design the pre-amp based on 
what we need, like working in the low-gain. Drew Weisenberger said we 
can schedule a meeting with their experts to discuss about the pre-amp. 
They also have many experiences on H8500 and other MaPMTs.

I was told Xiaochao will contact with the detector group so I am just 
passing this info to Xiaochao.

-- 
Best Regards
      @      _______/|______    0
    /| \_O. /      /       /   /|\
     |_|   /______|_______/  O_/|_|
     / \     | |      | |      /  \
             |        |
Zhihong Ye
Physics Department, Duke University
Office:  CEBAF Center F320, Jefferson Lab
Phone:   757-269-6122
Address: 12000 Jefferson Ave, 12H/F320, Newport News, VA 23606
_______________________________________________
Solid_ec mailing list
Solid_ec at jlab.org
https://mailman.jlab.org/mailman/listinfo/solid_ec