[Tpe] TPECal nomenclature

[Puneet Khetarpal]

Hi Mauri,

I discussed some of the Calorimeter and Fiber monitor stuff with
Sergey today and he mentioned that he'll be using the following
conventions for the ADC and TDC banks:

TPE Calorimeter: TPE0 or TPE1 (for ADCs, and TDCs)
Dense Fiber Monitor: DFM (just TDCs)
Sparse Fiber Monitor: SFM (just TDCs)

Do you think this is appropriate or desires revision?

Puneet

"No word is true until it is eaten" - 36 Lessons of Vivec, Sermon 27



On Fri, Nov 5, 2010 at 3:45 PM, Maurizio Ungaro <ungaro at jlab.org> wrote:
> Sounds good, if there are no objections I will adopt this in the software too.
> (let me know if it's layer 1 is left or right)
>
> best,
> mauri
>
> On Nov 5, 2010, at 3:42 PM, Larry Weinstein wrote:
>
>> Dear Mauri,
>>
>> We have been numbering them 1,1 to 1,6, then 2,1 to 2,6 ... then 5,1 to 5,1 where the first number is the layer and the second is the column.  I forget whether column 1 is beam left or right; Rob can check.
>>
>> Maurizio Ungaro wrote:
>>> Hi,
>>>
>>> I think TPEC is a good name for the bos bank for the calorimeter, don't you think?
>>>
>>> Also, is a nomenclature decided yet? I.e. numbering the tubes from 1 to 30 or organize them in layers?
>>> It could be horizontal, vertical or even concentric layers. Or something else?
>>>
>>> regards,
>>> mauri
>>> _______________________________________________
>>> Tpe mailing list
>>> Tpe at jlab.org
>>> https://mailman.jlab.org/mailman/listinfo/tpe
>>>
>>>
>>>
>>
>> --
>>                               Sincerely,
>>                               Larry
>>
>> -----------------------------------------------------------
>> Lawrence Weinstein
>> University Professor
>> Physics Department
>> Old Dominion University
>> Norfolk, VA 23529
>> 757 683 5803
>> 757 683 3038 (fax)
>> weinstein at odu.edu
>> http://www.lions.odu.edu/~lweinste/
>
>
> _______________________________________________
> Tpe mailing list
> Tpe at jlab.org
> https://mailman.jlab.org/mailman/listinfo/tpe
>