[Dsg-hallb_magnets] 9068 cRIOs

[Brian Eng]

Thanks Tyler, at least they're being consistent in their failures.

They're now both in EEL/231 where I'll leave them powered just to see if they fail again.

Which is what the 9067 was doing until it had to be pressed into service.

----- Original Message -----
> From: "Tyler Lemon" <tlemon at jlab.org>
> To: "Brian Eng" <beng at jlab.org>
> Cc: "dsg-hallb magnets" <dsg-hallb_magnets at jlab.org>
> Sent: Tuesday, April 3, 2018 4:51:29 PM
> Subject: Re: [Dsg-hallb_magnets] 9068 cRIOs

> Hi Brian,
> 
> Both 9068 cRIOs were surveyed today and I have both cRIO's at my desk in EEL
> 121c.
> 
> I connected the cRIOs to a bench-top power supply and like the other times the
> cRIOs failed, both cRIOs now powered on fine and started running their start-up
> applications.
> 
> Best regards,
> Tyler
> 
> 
> From: "Brian Eng" <beng at jlab.org>
> To: "dsg-hallb magnets" <dsg-hallb_magnets at jlab.org>
> Sent: Tuesday, April 3, 2018 12:34:32 PM
> Subject: [Dsg-hallb_magnets] 9068 cRIOs
> 
> Could someone see if those have been surveyed yet? If not call the radcon cell
> phone and see if you can get them out of the hall today?
> 
> Thanks