[Dsg-rich] Aerogel Pusher to 3D-print

[Seung Joon Lee]

Hi all,

All parts are ready. You can pick up from my desk.

See my comments below.

-manifold parts: still hard to screw in. you may want to increase nut 
thread radius by around 0.5 mm

-pipe 1~4 : you need to sand out the nose. I did it for one piece and it 
looks OK to fit in

- pipe plug: sand out too

- cables support: it is too tight for pipes. if you have trouble to fit 
pipes in, widen 0.5 mm for each side. Or sand out inside.


Regards,


Seungjoon




On 8/10/2017 2:06 PM, Tomassini Sandro wrote:
> Dear Seung,
>
> please find attached the stl files of the parts to be 3D printed.
>
> We need to have the parts  color black.
>
> In the folllowing list  you can find the quantities needed for each part:
>
> Aerogel pusher fixed.stl: 7+1
>
> Aerogel pusher fixed_MIR.stl: 7+1
>
> Aerogel pusher Mobile.stl: 7+1
>
> Aerogel pusher Mobile_MIR.stl: 7+1
>
> Many thanks in advance
>
> Sandro Tomassini
>
>

-- 
------------------------------
Seung Joon Lee
Staff Scientist, Detector Group
Thomas Jefferson National Accelerator Facility
12000 Jefferson Avenue, Newport News VA 23606
757-269-5476
sjlee at jlab.org