[Dsg-rich] Aerogel Pusher to 3D-print

[Tomassini Sandro]

Hi Seung,
Many thanks for now. Brian will pick them up since I am in Italy.
About the nut no problem since Brian has the relative tap.
Sandro

⁣Inviato da BlueMail ​

Il giorno 15 ago 2017 20:40, alle ore 20:40, Seung Joon Lee <sjlee at jlab.org> ha scritto:
>Hi all,
>
>All parts are ready. You can pick up from my desk.
>
>See my comments below.
>
>-manifold parts: still hard to screw in. you may want to increase nut 
>thread radius by around 0.5 mm
>
>-pipe 1~4 : you need to sand out the nose. I did it for one piece and
>it 
>looks OK to fit in
>
>- pipe plug: sand out too
>
>- cables support: it is too tight for pipes. if you have trouble to fit
>
>pipes in, widen 0.5 mm for each side. Or sand out inside.
>
>
>Regards,
>
>
>Seungjoon
>
>
>
>
>On 8/10/2017 2:06 PM, Tomassini Sandro wrote:
>> Dear Seung,
>>
>> please find attached the stl files of the parts to be 3D printed.
>>
>> We need to have the parts  color black.
>>
>> In the folllowing list  you can find the quantities needed for each
>part:
>>
>> Aerogel pusher fixed.stl: 7+1
>>
>> Aerogel pusher fixed_MIR.stl: 7+1
>>
>> Aerogel pusher Mobile.stl: 7+1
>>
>> Aerogel pusher Mobile_MIR.stl: 7+1
>>
>> Many thanks in advance
>>
>> Sandro Tomassini
>>
>>
>
>-- 
>------------------------------
>Seung Joon Lee
>Staff Scientist, Detector Group
>Thomas Jefferson National Accelerator Facility
>12000 Jefferson Avenue, Newport News VA 23606
>757-269-5476
>sjlee at jlab.org
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://mailman.jlab.org/pipermail/dsg-hallb_rich/attachments/20170815/d01a9802/attachment-0002.html>