[Dsg-hallc_nps] Fw: Samtec PMSD

[Brad Sawatzky]

That sounds great.  Those lead times will be just fine.

-- Brad

On Wed, 22 Jul 2020, Aaron Brown wrote:

> Dear Brad,
> Patrizia has approved DSG to start work on the project.
> In addition to the information sent to you by Marc, we have the following to
> add:
> 
>  1. The lead time for radial cables is relatively long, about 2 months.
>  2. We have experience with General Wire high voltage cables. General Wire
>     typically makes these cables after the order is received, and the lead
>     time for these are also relatively long, about 2 or 3 months.
>  3. We need to purchase the pins for the radial connectors.
>  4. For the SAMTEC end of the cables, we would need to purchase tooling.
>  5. We have tooling in the lab for making the radial connector end of the
>     cables.
> 
> DSG has experience making radial cables and molex connectors, which are very
> similar to the SAMTEC connectors.
> We have started looking at the parts and will be putting in the PRs in the
> upcoming week.
> 
> Sincerely,
> Aaron Brown
> 
> ----------------------------------------------------------------------------
> 

> From: Dsg-hallc_nps <dsg-hallc_nps-bounces at jlab.org> on behalf of Brad
> Sawatzky <brads at jlab.org>
> Sent: Wednesday, July 22, 2020 2:24 PM
> To: Marc Mcmullen <mcmullen at jlab.org>; Carlos Munoz Camacho <munoz at jlab.org>
> Cc: dsg-hallc_nps at jlab.org <dsg-hallc_nps at jlab.org>
> Subject: Re: [Dsg-hallc_nps] Fw: Samtec PMSD
> 
> No, this connector was selected by French group.  My understanding is
> that these PMTs are (relatively) low voltage, but I think they are still
> planning to run around 1000--1100V.
> 
> I'm CC'ing Carlos to see if he has more information on the SAMTEC
> connectors and/or can confirm the part numbers (on slide 10).
> 
> -- Brad
> 
> On Wed, 22 Jul 2020, Marc Mcmullen wrote:
> 
> >
> ----------------------------------------------------------------------------
> >
> 

> > From: Marc Mcmullen
> > Sent: Wednesday, July 22, 2020 2:01 PM
> > To: Dsg-hallc_nps <dsg-hallc_nps-bounces at jlab.org>; Brad Sawatzky
> > <brads at jlab.org>
> > Subject: Samtec PMSD
> >
> > Hi Brad,
> > We are reviewing the NPS documents you sent. Are you aware of the voltage
> > rating of this connector? The data sheet rates it for 600V max.
> > Regards,
> > Marc
> 
-- 
Brad Sawatzky, PhD <brads at jlab.org>  -<>-  Jefferson Lab / Hall C / C111
Ph: 757-269-5947  -<>-  Fax: 757-269-5235  -<>- Pager: brads-page at jlab.org
The most exciting phrase to hear in science, the one that heralds new
  discoveries, is not "Eureka!" but "That's funny..."   -- Isaac Asimov