[G12] gsim and calib_user.RunIndexg12

[Craig Bookwalter]

Meh, it seems like the whole writing all the constants from 56855 to 
runs 1 and 10 was a bad idea. I've restored RunIndexg12 back to its 
original state. My apologies if I ruined anyone's monte carlo.

Craig Bookwalter wrote:
> Hi folks,
>     I have copied constants from run 56855 to runs 1-10 for use with 
> gsim. This process was not at all easy, especially for something that I 
> imagine is done for every rungroup, so perhaps I have made a colossal 
> error. In that spirit, I saved the output from all commands I ran and 
> also all the subsystems that failed to make it into the run index for 
> runs 1-10.
>
> However, if everyone uses calib_user.RunIndexg12 for their MC from here 
> on, we should be able to at least debug knowing we're using the same 
> sets of constants. You can check on your favorite set of constants on 
> the CalDB query page:
>
> http://clasweb.jlab.org/cgi-bin/caldb/cq.pl
>
> Aloha.
>
> --cb
>
>   


-- 
-------------------------------------------------------------------------
 Craig Bookwalter			FSU Office:  (850) 644 3808
 Department of Physics			JLab Office: (757) 269 5465
 Florida State University		craigb at hadron.physics.fsu.edu
 Tallahasse, FL 32306			craigb at jlab.org		


"One toke? You poor fool. Just wait till you see those (expletive) bats."
-------------------------------------------------------------------------