[Halld-tagger] Tagger hall plans

[Richard Jones]

Fernando,

I am going to propose that we set things up in the ESB area when we arrive,
and do what setup and testing we can there prior to the move-in date in the
first week of October or thereabouts.  Any objections?

-Richard Jones


On Thu, Aug 21, 2014 at 10:03 AM, Fernando J Barbosa <barbosa at jlab.org>
wrote:

> Hi Richard, Alex,
>
> We will start removing the electronics from the tagger hall on 22 Sept
> 2014 in preparation for beam on 29 Sept 2014. All the cables will be
> disconnected from the modules but remain in place with the mini-racks; we
> then remove the crates/chassis with the modules and move them to a safe
> place, probably the ESB.
>
> You have indicated that you will be bringing the TAGM to JLab during the
> week of 9/1. In view of this, you only have two weeks (weeks of 9/8 and
> 9/15) to install, connect and test the TAGM. Is this enough time to do any
> significant work (setup software, controls, readout, etc)? Or should we
> plan to work in the ESB, which allows limited testing (limited number of
> cables, no 208V for the crates so power is an issue anywhere outside of the
> tagger hall)?
>
> Please work out a viable plan and let me know ASAP. If we are not going to
> do anything in the tagger hall, we could go ahead and start removing the
> electronics earlier so we are not rushing later.
>
> Best regards,
> Fernando
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://mailman.jlab.org/pipermail/halld-tagger/attachments/20140821/878050ca/attachment.html