[Dsg-rich] RICH exit window status update

[Tyler Lemon]

Hello, 

Today, Kevin, Tom, and DSG were able to remove the exit window frame from RICH using the gantry. Once we placed the exit window frame on the floor, we were able to cut and glue all four sides of the tedlar-mylar-tedlar exit window fabric to the frame. Attached is a photo of the exit window at the end of today. 

Overnight, the epoxy should cure and tomorrow we plan on further trimming the exit window fabric to size. We also plan to fit the foam gasket to the back of the detector shell to make a gas tight seal between the shell and the exit window frame. 

Depending on whether the epoxy has cured enough, we will then place the complete exit window back onto the detector shell. 

Best regards, 
Tyler 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://mailman.jlab.org/pipermail/dsg-rich/attachments/20170518/88c12aa3/attachment-0001.html>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: RICH Exit window clamped after gluing 2017-05-18.JPG
Type: image/jpeg
Size: 1221068 bytes
Desc: not available
URL: <https://mailman.jlab.org/pipermail/dsg-rich/attachments/20170518/88c12aa3/attachment-0001.jpe>