[Dsg-rich] 3D Print componets

[Seung Joon Lee]

They cannot be printed without supports.

If you want clean surfaces, then you need to make thin supports.

Since I will be out of town for two weeks, Brian may be able to help you.

Seungjoon



On 11/10/2017 8:25 AM, Dario Orecchini wrote:
> Hi Seungjoon,
>
> as anticipate, attached you'll find other components to realize by 3D 
> Printer.
> For each of the components must be done only one piece.
> For the component, "Cooling Pipe Lower Support Link", I'm not sure if 
> it's length is
> inside the capacity of the printer .... let me know.
>
> Thanks so much for your collaboration,
> best regards
> Dario
>

-- 
------------------------------
Seung Joon Lee
Staff Scientist, Detector Group
Thomas Jefferson National Accelerator Facility
12000 Jefferson Avenue, Newport News VA 23606
757-269-5476
sjlee at jlab.org