[Dsg-rich] Stainless Steel Tubing Inquiry

[Matthew Marchlik]

Hi Marc,

Yes, it looks sound to me.

Verify all tubing and components have pressure ratings greater than 90 psig.

Since the orifices could produce some thrust, albeit small, clamp down the manifold to something to restrain.

Matt

----- Original Message -----
From: "Marc McMullen" <mcmullen at jlab.org>
To: "Matthew Marchlik" <marchlik at jlab.org>
Cc: "dsg-rich" <dsg-rich at jlab.org>
Sent: Friday, September 29, 2017 9:23:10 AM
Subject: Re: Fwd: Stainless Steel Tubing Inquiry

Hi Matt,

I want to set up a flow rate test using 1/2" 316 steel pipe manifold 
(see attached drawing) on the  valve panel compressed air outlet. For 
the test we will use 40 - 60' of 1/2 nylon tube, and all Swagelok 
stainless steel fittings. The test is to determine the flow at 60psi. 
The relief is setup at 90psi. Is this ok.

Thanks,

Marc


On 9/28/2017 1:56 PM, Matthew Marchlik wrote:
> Marc,
>
> The PVC coated tube from McMaster is ASTM A269, its acceptable from a pressure system standpoint. Let me know what tubing you decide on.
> https://www.mcmaster.com/#3331k13/=19kz7gr
>
> Matt
>
> ----- Forwarded Message -----
> From: "nj sales" <nj.sales at mcmaster.com>
> To: "Matthew Marchlik" <marchlik at jlab.org>
> Sent: Thursday, September 28, 2017 1:49:28 PM
> Subject: RE: Stainless Steel Tubing Inquiry
>
> Hi Matt,
>
>
>
> The manufacturer states that the tubing is made from welded 316L stainless steel ASTM A269.
>
>
>
> Charlotte
>
>
>
>
> From: Matthew Marchlik <marchlik at jlab.org>
>
> Sent: Thursday, September 28, 2017 9:54 AM
>
> To: nj sales <nj.sales at mcmaster.com>
>
> Subject: Re: Stainless Steel Tubing Inquiry
>
>
>
>
> Hi,
>
>
>
> Does the manufacturer provide any ASTM specifications for the stainless steel tubing?
>
>
>
> Matt
>
>
>
> ----- Original Message -----
>
> From: "nj sales"
>
> To: "Matthew Marchlik"
>
> Sent: Thursday, September 28, 2017 10:51:19 AM
>
> Subject: Stainless Steel Tubing Inquiry
>
>
>
> Hi Matt,
>
>
>
>
>
>
>
> I attached the available specifications sheet and drawing of this stainless steel tubing with plastic exterior ( 3331K13 ). We consider the manufacturer information proprietary. Let me know which additional information you need and I will look into this further.
>
>
>
>
>
>
>
> Charlotte
>
>
>
>
>
>
>
>
>
> From: marchlik at jlab.org
>
>
>
> Sent: Thursday, September 28, 2017 9:33 AM
>
>
>
>
>
> Message
>
> Hi, I would like to have more detailed information on the material specs for tubing 3331K13. Who is the manufacturer? Thanks
>
> From
>
> Matt Marchlik ( marchlik at jlab.org )
>
> JLAB

-- 
Marc McMullen
Detector Support Group
757-269-7738