[Dsg-hallc_controls] connector-to-terminal-block adapter needed for APC UPS relay card

[Steve Lassiter]

Yes we have a few A/B terminal blocks available. But dont you need to use a terminal block that is already connected to a module? Are you proposing to add a new module? 

Steven 

----- Original Message -----

From: "Tyler Lemon" <tlemon at jlab.org> 
To: "dsg-hallc controls" <dsg-hallc_controls at jlab.org> 
Sent: Thursday, July 5, 2018 9:09:07 AM 
Subject: [Dsg-hallc_controls] connector-to-terminal-block adapter needed for APC UPS relay card 



Hello Steve, 



To be able to wire the APC UPS's relay card that we installed on Tuesday to the PLC, we will need an adapter to convert the 25-pin d-sub connector to a terminal block. 



Would Hall C have one of these adapters on hand? 


If not, I can submit a PR for one. 



Best regards, 

Tyler 

_______________________________________________ 
Dsg-hallc_controls mailing list 
Dsg-hallc_controls at jlab.org 
https://mailman.jlab.org/mailman/listinfo/dsg-hallc_controls 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://mailman.jlab.org/pipermail/dsg-hallc_controls/attachments/20180705/b0386939/attachment.html>